- OBJECTIVE:
The purpose of this Standard Operating Procedure (SOP) is to describe the procedure for Operation, maintenance and Calibration of Stainless steel measuring scale.
- SCOPE:
This SOP is applicable to Stainless Steel Measuring Scale at manufacturing facility.
- RESPONSIBILITY:
- Analyst/Section Head or his designee shall be responsible for follow the SOP.
- The Head of Quality Control Department or his designee shall be responsible for implementation of the SOP.
- PROCEDURE:
4.1 PRELIMINARY CHECK : |
Check that the measuring scale is clean, If not, then clean with a soft cloth duster.. |
4.2 BASIC OPERATION |
Place the measuring scale on sample to be analyzed and directly read the measurement from the’0’ mark in millimeters (mm) / centimeters (cm) / inch. 4.3 MAINTENANCE : Preserve the stainless steel measuring scale away from water to avoid rust formation. If found rusty over long usage, then replace with new measuring scale. |
- CALIBRATION :
Calibration Frequency: Yearly
Calibrate the instrument by approve external party.
- TRAINING:
Trainer : Head – Quality Control
Trainees : Sectional Heads / Analyst / Officers
- DISTRIBUTION:
Controlled Copy No.1 : Head of Department – Quality Assurance
Controlled Copy No.2: Head of Department – Quality Control
Original Copy : Head – Quality Assurance
- ANNEXURE:
Nil
- REFERENCES:
Nil
- REVISION HISTORY: